Supported email senders
Connect SMTP or SendGrid in Settings > Channels > Email. Enter the sender name and address recipients should see, then save the connection details provided by your email service.
Secrets stay hidden
Enter credentials only in the connection's setup or credential-update form. After saving, Wepy hides secret values and shows the connection's name and status.
Check and control the connection
- Save the connection with a recognizable internal name.
- Run the connection check before selecting the sender in a campaign.
- Set a messages-per-minute limit that does not exceed the provider account limit.
- For SendGrid, configure the Wepy event webhook shown for that connection if you need delivery and engagement updates.
- After rotating private details, run the connection check again before sending; Wepy removes the previous verified state until the replacement passes.
- If a connection is disabled, use Turn on and check. It stays disabled unless the live provider check succeeds.
Safe troubleshooting
Do not paste sender credentials into support email or screenshots. Report the connection name, status, page, and approximate time instead.